Other motorcycles for sale in Ludlow, Massachusetts

1-2 of 2

Sort By

Other Makes : MC400 1973 maico 400 mc early radial

Other Makes : MC400 1973 maico 400 mc early radial

$2,500

Ludlow, Massachusetts

Year 1973

Make Other Makes

Model MC400

Category Off Road Motorcycles

Engine 386

Posted Over 1 Month

Maico 400 radial. This is an early radial model with the thin web between the fins. Runs and shifts good, picks the front end up with just the throttle. Clutch has been updated with small clutch basket using a long pin so that the big clutch cover can be used. Clutch works nice and easy, doesn't drag when running in gear with the lever in. Mikuni carb is jetted so it runs crisp. I didn't have the bottom end apart on this one, but the rod and main bearings felt very good and within tolerance. Kick lever knuckle has been repaired, but the splines are very nice. Pipe s an aftermarket, and a 78 CR 250 Honda muffler has been welded on. Most of this bike is the way I received it, and I planned to just ride it, so some of the cosmetics are unfinished. The gas tank was painted but needs to be sealed, as it leaks on the seams. New petcocks, new shift linkage, and a new piston ring was installed on the 77.56 Mahle piston. Tank and seat are original, forks look good and are not leaking. Please check all of the photos and ask questions. . $250 Paypal deposit within 48 hours, and the remainder to be paid in 7 days. Buyer is responsible for shipping, or local pick up. :

Other Makes : VA 125 Rickman Montesa VA 125

Other Makes : VA 125 Rickman Montesa VA 125

$2,000

Ludlow, Massachusetts

Year 1973

Make Other Makes

Model VA 125

Category Off Road Motorcycles

Engine 125

Posted Over 1 Month

Rickman special with a Montesa VA125 motor. I decided to use this frame rather than spend a fortune looking for an original Montesa VA125 frame. I used lots of NOS parts for this build, and the only thing needed for the swap was to relocate a couple motor mounts. It has the Zundapp pipe modified to fit the Montesa cylinder. The fenders and seat base are NOS, but the rear was red, and the blue paint did not match well. I have more photos coming soon. I also installed new levers, Michelin tires, NOS spokes, NOS rear sprocket, new main bearings and seals, the kicker and kick shaft were new when I went through the motor. It has the enduro ignition, and the OEM ignition will go with it. Nice Betor forks, Curnutt rear shocks are like new. New cables. The frame has been painted because I was quoted $1500 for nickel plating. It shifts fine, will sit and idle, handles like a Rickman should. This is a great bike for a beginner or collector, or just a pit bike. Please check the photos and ask questions. I have way more money into this in parts than I am asking. $250 Paypal deposit within 48 hours, and the remainder to be paid in 7 days. Buyer is responsible for shipping, or local pick up.On May-07-15 at 19:58:55 PDT, seller added the following information: