Honda Cx500 motorcycles for sale in Texas

1-3 of 3

Sort By

2015 Honda PCX 150

$6,000

Georgetown, Texas

Year 1979

Make Honda

Model Cx 500

Category -

Engine -

Posted Over 1 Month

1979 Honda CX 500. This is a totally customized, one-off bike built by a very talented bike builder out of North Carolina!! It runs good, but needs a little fine tuning,because of the short, straight pipes. I've been told that some short baffles would give it the back pressure it needs to run perfectly, but I just haven't taken the time to do it. These CX 500s are becoming more and more sought after. They were only sold here in the U.S. from 1978-1982, so there are not a lot of them out there flooding the market. I have a clear North Carolina title on it. I haven't had the time to go get it titled here since I moved back to TX last year. If you have any questions about it or would like to come take a look at it, don't hesitate to contact me. If you are wanting to take it for a test drive, you will need a state issued drivers license with a motorcycle endorsement and $1,000.00 in cash for me to hold during your ride, in case of any unexpected accidents or incidences.

2009 Honda Cbr 600

$2,845

El Paso, Texas

Year 1978

Make Honda

Model Cx 500

Category -

Engine -

Posted Over 1 Month

1978 Honda Cx 500, This is a 1978 Honda CX500 that has been converted to a cafe racer. The CX is one of the most coveted platforms in which to create a cafe racer. A cafe racer is one of the most unique kind of bikes on the road. The bike has just over 14,000 original miles. It is in amazing condition. It has been completely taken apart and rebuilt from the frame up. The frame was sand blasted and painted. The engine and every other part has been cleaned, buffed or replaced as needed. It has a brand new Ignitech CDI box, rebuilt carbs jetted for opened air and exhaust, new air filters, new Shorai lithium iron battery that has been moved to the bottom of the motorcycle. New speedometer and tachometer. All wiring has been redone and brand new tips and connectors throughout. New headlight and turn signals. Custom made tobacco brown seat. Forks have been rebuilt. New steering stem bearings, new front axle bearings, completely serviced shaft and final drive. Even the manufacturer suggested shaft lubrication was used; molybdenum disulfide. This bike has been indoors since being worked on and is completely clean. The only things that need to be done to be ready for the road is the exhaust, mounting the tail light and CDI and rectifier, and simply bolting on the headlight..which I can do for you if you'd like. This is an unbeatable deal for a truly unique motorcycle. $2,845.00 3159550911