Harley Davidson Street motorcycles for sale in Nesbit, Mississippi

2008 Harley-Davidson STREET GLIDE CVO

$2,300,000

Nesbit, Mississippi

Year 2008

Make Harley-Davidson

Model STREET GLIDE CVO

Category -

Engine 120 cc

Posted Over 1 Month

Custom built Fat Bagger Razorback with a Fresh Jims 120 race motor. Everything on this bike has been rebuilt or replaced as needed to make it road worthy. Most work performed at Southern Thunder Harley Davidson and also can be veiwed there. Call or text 901-409-0970

2014 Harley-Davidson SPORTSTER 883 IRON

$18,000

Nesbit, Mississippi

Year 2008

Make Harley-Davidson

Model STREET GLIDE CVO

Category -

Engine 2,000 cc

Posted Over 1 Month

“Has a JIMS 120 connected to an H-D Cruise Drive six-speed tranny. Inside the base of the stroker motor is a set of pressed JIMS flywheels and 4340 steel con rods with a 4 1/2-inch stroke. Combined with the 4 1/8-inch bore forged slugs and 10:1 compression, the motor pumps out over 100 hp and 120 lb-ft of tire-melting torque. Large 2.08-inch intake valves in the JIMS heads are actuated by 0.635-lift SE cams that help air escape from the FBI True Dual exhaust system. Induction is handled by a combo of a Zipper's throttle body and H-D injectors lit up with a ThunderMax ignition unit.To equal the motor output, just as much went into the styling of the Razor. A sleek Russ Wernimont 5 1/2-gallon fuel tank is flanked fore and aft by FBI fenders with a wide unit out back to cover the 200mm tire. Rear Avon skins are wrapped around RC Comp Holeshot wheels and rotors that are clamped by HHI calipers. Using FBI's single caliper fork leg with only one six-piston brake to open up the front.”Now is your chance to own a Fat Bagger custom bike at less than half the cost of a new one.I was getting it ready for the second 50K when I got the fever and bought a new Road Glide CVO. Most everything on this bike has been replaced! New factory rebuilt motor by Jims,still under factory warranty. New wheel bearings, new clutch with a Harley centrifugal pressure plate, rebuilt primary, new belt and rear pulley, new 10" Cubby apes with new Harley Aileron grips, new neck bearings, new Pro Glide motor mount and swing arm bushings, new bearings in tranny, new fuel pump,New Kuryakyn Diamond cut headlight with 100 watt Hella bulb, new Avon 200 rear tire, 4k on front tire, new Harley battery, even new batteries in the fobs, fresh paint 2 years ago by O's Custom Paint in Bartlett. The seat is custom made by Danny Gray covered in leather with a Danny Gray rider back rest. Even the starter and fuel pump relays are new. This bike has been meticulously maintained and is in excellent condition. Call or text Kevin at 901 409 0970 for any questions.

2008 Harley-Davidson STREET GLIDE SPECIAL

$21,000

Nesbit, Mississippi

Year 2008

Make Harley-Davidson

Model STREET GLIDE SPECIAL

Category -

Engine 2,000 cc

Posted Over 1 Month

Now is your chance to own a Custom built from the ground up Fat Bagger Razorback bike at less than half the cost of a new one.Has a JIMS 120 connected to an H-D Cruise Drive six-speed tranny. Inside the base of the stroker motor is a set of pressed JIMS flywheels and 4340 steel con rods with a 4 1/2-inch stroke. Combined with the 4 1/8-inch bore forged slugs and 10:1 compression, the motor pumps out over 100 hp and 120 lb-ft of tire-melting torque. Large 2.08-inch intake valves in the JIMS heads are actuated by 0.635-lift SE cams that help air escape from the FBI True Dual exhaust system. Induction is handled by a combo of a Zipper's throttle body and H-D injectors lit up with a ThunderMax ignition unit.To equal the motor output, just as much went into the styling of the Razor. A sleek Russ Wernimont 5 1/2-gallon fuel tank is flanked fore and aft by FBI fenders with a wide unit out back to cover the 200mm tire. Rear Avon skins are wrapped around RC Comp Holeshot wheels and rotors that are clamped by HHI calipers. Using FBI's single caliper fork leg with only one six-piston brake to open up the front.I was getting it ready for the second 50K when I got the fever and bought a new Road Glide CVO. Most everything on this bike has been replaced! New factory rebuilt motor by Jims,still under factory warranty. New wheel bearings, new clutch with a Harley centrifugal pressure plate, rebuilt primary, new belt and rear pulley, new 10" Cubby apes with new Harley Aileron grips, new neck bearings, new Pro Glide motor mount and swing arm bushings, new bearings in tranny, new fuel pump,New Kuryakyn Diamond cut headlight with 100 watt HELLA bulb, new Avon 200 rear tire, 4k on front tire, new Harley battery, even new batteries in the Fobs, fresh paint 2 years ago by O's Custom Paint of Bartlett, TN .The seat is custom made by Danny Gray covered in leather with a Danny Gray driver back rest. Even the starter and fuel pump relays are new. Call or text Kevin at 901-409-0970

Harley Davidson Street motorcycles for sale in Nesbit, Mississippi

2008 Harley-Davidson STREET GLIDE CVO

2014 Harley-Davidson SPORTSTER 883 IRON

2008 Harley-Davidson STREET GLIDE SPECIAL

Narrow Results

Current Search Reset All

ZIP Code

Year

Price

Options

Showcase Ads